Techno Brad Nailer Pneumatic Air Nailers

1. 3-in-1 oil into the air inlet .

2.Install a quick connect fitting to the tool .

3. Connect the tool to an air compressor Make sure the magazine must be empty of all fasteners and the hose has a rated working pressure exceeding 200psi (13.8 bar) and a female quick coupler.

4. Regulate the air pressure to obtain 62 psi(4.1bar) at the tool. Check the operation of the safety yoke mechanism following the instructions in this manual.

5. Insert fasteners into your tool following the instructions of loading the tool.

6. Reconnect the hose to the tool.

7. Test for proper fastener penetration by driving fasteners into a piece of wood. If the fasteners do not achieve the desired penetration, regulate the air pressure to a higher setting until the desired penetration is achieved. Do not exceed 7 bar(100psi) at the tool.